Samsung Galaxy J6 (2018) (SM-J600f) firmware (Unbrick/Repair)

By | April 19, 2021

Un-bricking, upgrading and/or repairing software faults on your Samsung Galaxy J6 (2018) (SM-J600f) can easily be done using this official firmware.

This is a four file (AP, BL, CP and CSC) repair firmware with which you can unbrick your smartphone and/or fix other software faults on the device.

This firmware fixes software issues like:-

  • Un-brick bricked devices
  • Fix apps force closing
  • Device getting stuck during use, or lagging
  • Fix stuck on boot logo
  • Fix boot loop
  • Remove custom recovery (e.g, TWRP)
  • Remove root and restore default system files
  • Help upgrade/ update Android version to latest security patch
  • And just any software related faults

Before downloading any firmware for your Samsung device, check and confirm that the firmware is meant for your exact device model. This is necessary to avoid downloading the wrong file, causing your device to brick.

Download Samsung Galaxy J6 (2018) firmware

Model SM-J600f
Android version 9.0 (Pie)
J600FPUU6BSK6 Download
J600FXXU5BSH5 Download (SER)
Download (SKZ)
J600FXXU4BSF5 Download
J600FPUU3BSD6 Download
Model SM-J600f
Android version 8.0.0 (oreo)
J600FPUU3ASA1_J600FSER3ASA1 Download
J600FPUU3ARK1 Download
J600FSER3ARJ1 Download
J600FXXU3ARH2 Download | Download
J600FPUU1ARE3 Download

How to flash Samsung Galaxy J6 (2018) (SM-J600f) via Odin

Note: Backup all important data (messages, contacts, app data, settings, etc) as these might be erased once flashing is successful.

Charge your phone to at least 50% before you proceed with the flashing instructions below. Read and follow all steps carefully, especially if you are not very experienced in flashing Samsung devices.

  • Download and install Samsung official USB driver on your computer. (Skip step if already installed)
  • Download and extract (unzip) the firmware file
  • Download Odin Tool
  • Extract the contents of Odin ZIP file
  • Run/Launch Odin.exe
  • Reboot Phone in Download Mode (press and hold Home + Power + Volume Down buttons)
  • Connect device to Computer via USB cable and wait until you get a blue sign in Odin
  • Select/ add the four firmware files extracted in step one.
    • For instance, BL is the bootloader file- click BL in Odin and select that file. In the same way, click AP, CP, and CSC select the files accordingly. See below screenshot
Samsung Odin
  • Make sure re-partition is NOT ticked
  • Click the start button and wait few minutes for the flashing process to begin and complete
  • Once flashing is complete, disconnect device and boot normally.

I am Owner of ( Website. I Build this website for helping Peoples for Finding the Driver & Software they need to their Operating System.

Leave a Reply

Your email address will not be published. Required fields are marked *