Itel P36 (W6501) stock firmware flash file

Itel P36(W6501) manufacturing facility (official) flash data (stock firmware) will assist you blink and also restore your phone to its default factory state. It will get rid of origin, infection, un-brick, and also repair your device if it’s stuck on boot logo. If your phone delays, after flashing it should be better.

It is advised that you backup current firmware as well as all other crucial information since, flashing this firmware will entirely remove your phone information. Likewise, only blink your device if you in fact know what you’re doing. This is to stay clear of messing up your tool, or turning it right into a brick.

Subsequently, guarantee the device is charged up to at the very least 30% so the procedure is not cut off as a result of low battery. If there’s a damaged link, do not hesitate to report through the comments area or use the call kind.

Build Firmware Size
W6501- F3111 -9.0- OP-V020-20200429 Download 970 MEGABYTES

Flashing guidelines

You require tools like SPD Upgrade Tool or CM2 to blink this firmware. Obtain a working USB cord, then adhere to the guidelines below-

  • Unpack downloaded firmware to a vacant folder
  • Make sure you’ve set up the needed drivers on your COMPUTER.
  • Launch flashtool and also load the firmware. You might need to wait a few seconds for it to process completely
  • Now power off your gadget and also visit this site to read complete blinking instructions if using SPD Upgrade Tool.

If you require any aid on this gadget or flashing guidelines, or you’ve obtained other payment- do not be reluctant to post in the comments section below. We do our best to respond and address your concerns.

Leave a Reply