Alldocube X Neo (T1009) official firmware installation

When you blink Alldocube X Neo (T1009) with this main supply firmware, the gadget will certainly be recovered to its default factory state. In significance, it will eliminate root, infection, un-brick, as well as fix your gadget if it’s stuck on boot logo. For problems like delaying and applications pressure closing, after blinking it ought to be much better.

Additionally, you should think about making a back-up of your present firmware, and also all other vital data on your phone. Blinking will totally remove your phone. Additionally, you must only flash your gadget if you in fact understand what you’re doing. To stay clear of ruining your device, or turning it into a brick.

It’s also vital that your tool is billed up to a minimum of 30% so the procedure is not interrupted because of shutdown.

If there’s a busted web link, do not think twice to report via the comments area or use the contact kind.

Firmware download link

Version Firmware Size
XNeo( T1009)- EN-20200709 Download 1.52 GB
XNeo( T1009)- EN-20200701 Download 1.52 GB

Flashing instructions

You need a tool like QPST, CM2QLM, QFIL, and so on, to blink this firmware. Get a working USB cable, then follow the guidelines listed below-

  • Unpack downloaded and install firmware to an empty folder
  • Make sure you’ve installed the needed drivers on your PC.
  • Launch flashtool as well as load the firmware. You might require to wait a few seconds for it to procedure completely
  • Now power off your tool and also go here to review full flashing guidelines if making use of QPST.

If you require any help on this device or flashing directions, or you’ve got various other payment- do not think twice to upload in the remarks area listed below. We do our best to respond and also answer your questions.

Leave a Reply